ip 192.168.1.10/24 192.168.1.1 CopyĪfter assigning a default gateway address to PC1, you will see that the connection is successful when pinging the serial port of R1 again. When you ping the FastEthernet 0/0 port of Router R1 from PC1, you will see that the connection is successful, but you will not be able to ping the serial port because the default gateway is not configured in PC1.Īccording to the topology you created, VPCS PC1’s Default Gateway IP address should be the IP address of Router R1’s FastEthernet 0/0 port. R1(config-if)# ip address 192.168.2.1 255.255.255.0Īssign an IP address to the serial port of R2 connected to R1. R1(config-if)# ip address 192.168.1.1 255.255.255.0Īfter configuring R1’s FastEthernet 0/0 port, also configure the Serial port connected to R2. To assign an IP address to Router R1 and activate the port, execute the commands below on the terminal. Also, you can use the “show ip” command to check the IP address information. Open the console by double-clicking on VPCS PC1 after running all devices, and execute the command “ip 192.168.1.10/24” to assign an IP address. Likewise, plug the Switch into the FastEthernet0/0 port instead of the Router’s Serial interface.Īdd one more Router to the workspace and connect R1 and R2 via serial interfaces. When you add an Ethernet Switch to the workspace from the All Devices panel, select the GNS3 VM in the window that opens.Īdd the VPCS device as a virtual computer to the workspace and select your server.Īfter activating the cabling option from the left panel, plug one end of the cable into the Ethernet port of the VPCS and the other end into one of the empty slots of the Switch. Open the project creation window by clicking CTRL + N or the icon in the tool menu and configure your project name and backup location and click OK.ĭrag and drop the c7200 device you added from the routers panel to the workspace. You can add FastEthernet, GigabitEthernet, or Serial Interface network adapters to the empty slots of the router.ĭetermine an appropriate Idle-PC value according to your computer not to use 100% of your host CPU and reduce its performance.Īfter checking the information of the IOS image you added in the router template window, close the wizard.Īfter installing GNS3 VM on Linux Mint, you can create a new project and start creating basic or advanced network topologies to prepare for your Cisco exams.
0 Comments
Leave a Reply. |